info
Google Groups no longer supports new Usenet posts or subscriptions. Historical content remains viewable.
Dismiss
Numark Matrix 2, CD DJ desk , 2003 ?
0 views
Skip to first unread message
N_Cook
Sep 29, 2011, 11:15:30 AM9/29/11
to
The central mixer separate.
Anyone happen to know where 2 fibre washers , as used on 1/4 inch jack
sockets, would have come from. They dropped on the bench , unnoticed. I
cannot see 2 being left over at assembly. The 2 sockets I had left in place
so not from there. No obvious place to put them. A fudge due to engineering
fixings alignment problem ?
In for bad output RCA/phono socket but now in there, the soldering elsewhere
is terrible , not PbF probably just not enough solder, ring cracks emerging
on the ps board including a wire jumper joint. Bodes ill for the 2 CD units
Anyone happen to know where 2 fibre washers , as used on 1/4 inch jack
sockets, would have come from. They dropped on the bench , unnoticed. I
cannot see 2 being left over at assembly. The 2 sockets I had left in place
so not from there. No obvious place to put them. A fudge due to engineering
fixings alignment problem ?
In for bad output RCA/phono socket but now in there, the soldering elsewhere
is terrible , not PbF probably just not enough solder, ring cracks emerging
on the ps board including a wire jumper joint. Bodes ill for the 2 CD units
N_Cook
Sep 30, 2011, 4:04:20 AM9/30/11
to
sheet metal work cock-up, the rear sub-chassis is 1.5mm shorter than the
front so 2 fibre washers, for padding out, so as not to strain/split the
plastic outer case
front so 2 fibre washers, for padding out, so as not to strain/split the
plastic outer case
0 new messages