Google Groups no longer supports new Usenet posts or subscriptions. Historical content remains viewable.
Dismiss

Unidentified connector type

6 views
Skip to first unread message

Samuel M. Goldwasser

unread,
Feb 23, 2011, 5:27:20 PM2/23/11
to
Please see:

http://repairfaq.cis.upenn.edu/Misc/conn-h.jpg
http://repairfaq.cis.upenn.edu/Misc/conn-p.jpg

These are 0.1" spaced and sort of compatible with the common AMP/Molex
headers/housings but not quite identical. Please don't do an extensive
search, but if you recognize the manufacturer/type, please reply here.

Thanks!

--
sam | Sci.Electronics.Repair FAQ: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites: http://www.repairfaq.org/REPAIR/F_mirror.html

Important: Anything sent to the email address in the message header above is
ignored unless my full name AND either lasers or electronics is included in the
subject line. Or, you can contact me via the Feedback Form in the FAQs.

N_Cook

unread,
Feb 24, 2011, 3:31:51 AM2/24/11
to
Samuel M. Goldwasser <s...@repairfaq.org> wrote in message
news:uhbbum...@repairfaq.org...

So what is the difference to Harwin/ Molex etc? other than the bulky looking
upright section of the pins half. Width of pins different to the usual? Is
there a retention lug on the unseen mating surface of the p pic that locks
into the recess pit in the h pic?


Samuel M. Goldwasser

unread,
Feb 24, 2011, 3:25:45 PM2/24/11
to
"N_Cook" <div...@tcp.co.uk> writes:

> Samuel M. Goldwasser <s...@repairfaq.org> wrote in message
> news:uhbbum...@repairfaq.org...
> > Please see:
> >
> > http://repairfaq.cis.upenn.edu/Misc/conn-h.jpg
> > http://repairfaq.cis.upenn.edu/Misc/conn-p.jpg
> >
> > These are 0.1" spaced and sort of compatible with the common AMP/Molex
> > headers/housings but not quite identical. Please don't do an extensive
> > search, but if you recognize the manufacturer/type, please reply here.

> > sam | Sci.Electronics.Repair FAQ: http://www.repairfaq.org/

> So what is the difference to Harwin/ Molex etc? other than the bulky looking


> upright section of the pins half. Width of pins different to the usual? Is
> there a retention lug on the unseen mating surface of the p pic that locks
> into the recess pit in the h pic?

Not absolutely sure, but the pins look the same make good contact with the
normal AMP/Molex sockets. There is a retention dimple and that does make it
more difficult to remove.

0 new messages