27" RCA TV Model:F27665 ~ Chassis:CTC203AX (Video?)

[AgapeDisciple]

Turned on my TV the other day and was missing video. Can still change
channels, hear audio, see the raster lines (I think), and go through
the menus. But I can't get video from the coax, s-vid, or rca inputs.

I saw where a couple of other people had the same problem a while back
and it was mentioned to "clean the glue off L14401 and resolder it."
But it didn't look like that solved their problem.

Any ideas?

Thanks,
Logan

[gnk]

Check for a bad connection on Connector P103 pin # 4, also check R14119
(15 K 2 watts).

GNK

[AgapeDisciple]

Thanks GNK! I'll check it out tonite.

BTW, did you have this same problem?

Logan

[AgapeDisciple]

I resoldered P103 Pin #4 and checked R14119 = 13K ohms. (Is that too
low?) I also checked the error codes. Here's what came up:

1 - 3 | 03 | 12.0V run fault | 12.0V source is failing.
2 - 3 | 03 | 12.0V run fault | 12.0V source is failing.
3 - 44 | 2C | F2 PIP module error | F2PIP fails to acknowledge.

And I resoldered L14401.

Any more ideas?

Logan

[gnk]

The only other information I can find for this chassis with similar
problems is to check for a Leaky C14112, .01/1kv, causing R14119 to
overheat.

Good luck.
GNK