Google Groups no longer supports new Usenet posts or subscriptions. Historical content remains viewable.
Dismiss
Kenwood Major - how to remove the large pulley?
20 views
Skip to first unread message
Leif Neland
Oct 30, 2012, 8:27:44 AM10/30/12
to
I found this old thread on archives, but no soluton, until I found a
manual on
http://forum.adepem.com/depemdocs/KENWOOD/KM001%20notice%20demontage.pdf
The solution for removing the pulley is simple, when you know it: :-)
Block the slow-turning "meat-grinder" output by attaching the meat
grinder, and block the rotating knife by putting a screwdriver in one
of the holes. Then turn the large pulley counter-clockwise, to unscrew
the axle and pulley.
The screwdriver will rest against the blunt side of the knife, so the
sharp side will not be damaged.
I write this to archive the solution forever ;-)
Leif
--
Husk kørelys bagpå, hvis din bilfabrikant har taget den idiotiske
beslutning at undlade det.
manual on
http://forum.adepem.com/depemdocs/KENWOOD/KM001%20notice%20demontage.pdf
The solution for removing the pulley is simple, when you know it: :-)
Block the slow-turning "meat-grinder" output by attaching the meat
grinder, and block the rotating knife by putting a screwdriver in one
of the holes. Then turn the large pulley counter-clockwise, to unscrew
the axle and pulley.
The screwdriver will rest against the blunt side of the knife, so the
sharp side will not be damaged.
I write this to archive the solution forever ;-)
Leif
--
Husk kørelys bagpå, hvis din bilfabrikant har taget den idiotiske
beslutning at undlade det.
0 new messages