>> How do I remove Candle Wax from KoolDeck??
Anything which dissolves it, is likely to allow it to flow further
into the pores of the KoolDeck. Might just spread out the problem to
a larger area of the deck surface.
I would first try to remove as much as possible from the surface in a
solid form. One classic old trick is to freeze it, as cold as is
possible... this converts the wax to a hard, brittle form which can
often be broken off of the surface to which it's clinging. For
removing wax from clothing, icewater is often recommended. You could
try solid ice, or icewater, or place a block of dry ice on it and
cover and wait a while, or try pouring liquid nitrogen over it. Too
much (or too sudden) cold might fracture the KoolDeck, though. so be
careful.
Save the use of solvents for removing the last bits that you can't get
out in solid form. You'd want to wet with the solvent, let the wax
soften and dissolve, and then pull out as much as possible... perhaps
rags, perhaps a flameproof vaccuum source, etc... and then repeat.
It's possible that the wax has already soaked into the pores in the
deck enough to permanently stain it or leave it slippery. If that's
the case, there may be no really thorough way to remove it, other than
to chip out the contaminated KookDeck and replace it.
Your pool contractor may know.
--
Dave Platt <
dpl...@radagast.org> AE6EO
Friends of Jade Warrior home page:
http://www.radagast.org/jade-warrior
I do _not_ wish to receive unsolicited commercial email, and I will
boycott any company which has the gall to send me such ads!