Hope you all, with your many years of wisdom at problem solving, can
help. I have a late 80's Alpenlite fiver that has an American Appliance
Model DST6 propane water heater. When I turn the switch on inside, it
immediately fires up and heats the 6 gallons to operating temperature.
When momma gets in the shower, she has plenty of hot water BUT as she
stands there (which she is prone to do!!) and the heater cycles to
heating again, it will fire up but after a moment or two, shut off and
the switch's red light comes on. I turn it off and back on and the
heater fires for a moment or two and shuts off. I do this routine 2 or
3 times and then it stays on just fine until later when I'm in the
shower and we start this process over again. Same thing doing the
dishes - midway through, we have to turn off and on a couple of times
to get it to stay on and continue heating. Any ideas of what may be the
problem or what I should look for/ check out to cure this beast and get
it to cycle normally?
Thanks in advance for all ideas,
David Rolando
PS. We drove the North Cascades Highway here in Washington yesterday
west to east - delightful. Due to the drought conditions here in the
NW, it has a record early opening this year. There's still snow in the
passes but the road was bare and dry. We came from the Skagit Valley
(Mt. Vernon/ Burlington) after spending a few days checking out the
early tulips/daffodils prior to the Tulip Festival.