Changing the mode on Sanwa RD 6000 radios

[CubanFlyer]

For information How to change the mode on Sanwas radios.

Thanks to David from Glasgow for this information.

Sanwa Mode 1 to 2 change via service mode
1. Switch the radio off.
2. Shift the left switch forward.
3. Hold down F.Mode and End.
4. Switch the radio on.
5. Flip back the left switch.
6. Scroll down to MOD.
7. Select mode 2.
8. Press End.
9. Switch the radio off.
10. Switch the radio back on.
1. unscrew aerial
2. remove all screws from the back
3. carefully lift the back off BE VERY CAREFUL AS THE TRAINER SOCKET WIRES
ARE SHORT AND SNAP EASILY
4. remove the spring / tensioner and seesaw assy from the elevator stick
5. remove the throttle ratchet asembly and stick travel limiters
6. refit to opposite sticks without the limiters

Re asemble the tx

1. With the radio off.
2. Shift all switches forwards / down .
3. Hold down F.Mode and End.
4. Switch the radio on.
5. Wait for a beep
6. Flip back the top left switch.
7. Release F.Mode and End.
8. Scroll down to MOD.
9. Select mode 2.
10. Press End.
11. Switch the radio off.
12. Switch the radio back on

SVC menus
Init-->YES (press yes button)
CH---->yes button selects 6 or 8
NEU--->sets neutral stick positions
TRV--->sets stick calibration
A/D--->VR1....VR6 stick pot values
MODE-->mode 1 or 2(stick orientations)
LCD--->All led's lit, some, some, none
SW---->press 'yes' to see switch positions
B*AL-->use +- to set batt voltage alarm
PULSE->Nor, LO, HI
V*Cal->'+' set voltage to 10.0 volts
All-CR>All clear

[tomekr]

This work well on my RD6000Super, but I have problem witk stick.
Elevator stick work on 50% of his travel and gas stick not cover all
avaible range. I think that i have to make stick calibration. Could tell
me someone how to do it ?.

--
tomekr
------------------------------------------------------------------------
tomekr's Profile: http://www.rcgroups.com/forums/member.php?u=101772
View this thread: http://www.rcgroups.com/forums/showthread.php?t=148222