Any Diesel Engine Experts?

[Tim Wescott]

I just got a Cox 049 with a Davis Diesel head running. It runs a bit
inconsistently; I'm still trying to sort out the best tuning that'll
give me a good flight. It tunes well on the ground, but in the air it
definitely unloads and starts to 'cackle' like it's under-compressed,
although it could be too rich; I suspect not enough compression because
usually an engine leans out a bit in the air.

It also puts out a lot of black gunk in the exhaust. I don't remember
this happening the last time I had that head on an engine, but Jimmy
Carter was president then so it may have spewed ink all over everything
for all I can remember.

Does any one know what the black stuff in the exhaust may be? And
should I expect the think to need a bit more compression in the air than
on the ground?

It's running a 7-4 prop, on a control-line trainer.

--

Tim Wescott
Wescott Design Services
http://www.wescottdesign.com

Do you need to implement control loops in software?
"Applied Control Theory for Embedded Systems" gives you just what it says.
See details at http://www.wescottdesign.com/actfes/actfes.html

[Anyolmouse]

"Tim Wescott" <t...@seemywebsite.com> wrote in message
news:JbadnQk-8fqeh_rV...@web-ster.com...

The most recent experience I have is with an OS 40FP with the Mecoa
conversion head. It has the right angle compression adjuster with a
stamped steel locking wrench.

It has always had black gunk in the exhaust. I ran Tygon tubing to the
tail of the airplane to keep as much off as possible. The last fuel I
bought from Davis Diesel had synthetic lube instead of castor lube. If
anything the black exhaust gunk was worse. I did break the engine in on
glow fuel before installing the diesel head as recommended.

I always start the FP40 with the compression reduced and using an
electric starter. (not recommended) Then I increase the compression and
adjust the needle valve and airbleed for the best transition from idle
to high speed as well as a little on the rich side from peak rpm. When I
get the pre-ignition frying or crackling sound I know that it has too
much compression. I back off on the compression and readjust the needle
valve.

If Davis Diesel is no help you might try Dr. Diesel at this site-
http://www.cafes.net/doctordiesel/default.htm

--
Anyolmouse

---- Posted via Pronews.com - Premium Corporate Usenet News Provider ----
http://www.pronews.com offers corporate packages that have access to 100,000+ newsgroups