I've been shooting 45 ACP (1911 and CZ 97B) for a few years and decided it
was time to get a 9 so I could shoot relatively cheap ammo without having
to load my own.
So, get the gun home and field stripping for the first cleaning is simple -
push a button and flip a lever and the slide literally will fall off. The
slide does not have to be locked back. Swab out the nooks and crannies,
lube, and assemble. The rotating barrel lock-up is an interesting action.
Re-assembly is simple with no pins to stab, just pull the slide back and
rotate a lever. All the internal bits seem to self-align.
At the range, put about 100 rounds (WWB) through it with one failure to
eject. The discharged round had been pulled out of the chamber but failed
to clear the slide and the action jammed when the old case interfered with
the new round. Simple to clear.
Checked the decocker action and it worked fine. It drops the hammer
abruptly after moving the firing pin up out of the way. Leave the decocker
in place and the trigger is disconnected. This gun cannot be "cocked and
locked" but decocked and locked or unlocked is available with the DA. It
has a firing pin safety so decocked and unlocked is a viable carry option.
Trigger is firm and smooth in double action. Fairly crisp and smooth in
single action. Better than the 97B since it does not move the hammer
further back in SA mode.
At 7 yards it was easy to make a ragged hole about an inch and a half above
point of aim. At 15 yards the 15 round group was larger but still easily
covered by the palm of my hand. At 25 yards I really lost the bubble with
rounds on paper but no grouping. Obviously the gun can do better than I
can. Will have to try it from a rest next time.
I have large hands and the grip seemed a good fit. The trigger reach might
be a little more comfortable for someone with shorter fingers or smaller
hands. It wasn't natural to keep my finger perpindicular to trigger travel
but it didn't seem to impact the shooting at short range. It might have
contributed to my "challenges" at 25 yards.
Nothing major to note in post range cleaning. The recoil spring/guide
assembly looks difficult/impossible to disassemble. The rod is plastic so
probably just replace periodically rather than worrying about doing more
than a wipe down.
It seems hard to beat for the price (ok, 1 year warranty sucks) with fine
fit and finish but some no-no's: +p and +p+ are not recommended and no dry
firing. The manual goes so far as to recommend the snap-caps with a spring.
At least now I can shoot relatively inexpensively at the local ranges that
require factory loads. Will have to get some snap-caps so I can work on
trigger technique though.
--
---
there should be a "sig" here
---------------------------------------------------------------------------
Learn about rec.guns at http://www.recguns.net
Win a Fulton Armory AR-15 rifle chambered in 6.8mm Rem SPC and protect your
2nd Amendment Rights at the same time! See details at http://www.myguns.net
---------------------------------------------------------------------------