EVER HEAR OF A 31/32-28 TAP?
Randy
and Google both come up with nothing. does it exsist?
Thank You,
Randy
Remove 333 from email address to reply.
sta...@prolynx.com
Retaining ring for the spout on a kitchen set? Don't think there's
any standard sizes there. Bonnet on a wall tap might be a standard
thread about that size, for a given value of "standard", but I don't
think it's in the SAE thread set. Internally, the actual shaft part
that moves is a very coarse thread, some Acme, some multi-start, know
that from taking a hundred or so scrap ones apart, no standards
there. If you need a tap for that stuff, it's time to quit pinching
pennies and go get a new one! With a lathe, you can cut a new tap to
fit, but it'll take more time than a new one's worth unless you're
dead and your time's worth nothing.
Stan
dca...@krl.org
> Some guy called me looking for a 31/32" - 28 tpi tap for a faucet. MSC
> and Google both come up with nothing. does it exsist?
>
> Thank You,
> Randy
You are sure it is not metric?
Dan
Randy
All I know is what the guy asked me for.
dca...@krl.org
> >You are sure it is not metric?
>
> > Dan
>
> All I know is what the guy asked me for.
>
> Thank You,
> Randy
I just asked because MSC sells a 24mx1 die. That would be close. And
maybe your guy figured that since it was less than an inch and more
that 15/16th that it must be 31/32 dia. even though he measured .945
Dan
Winston
> On Thu, 4 Feb 2010 20:00:04 -0800 (PST), "dca...@krl.org"
> <dca...@krl.org> wrote:
>
>> On Feb 4, 7:57 pm, Randy<rbraun...@enter.net> wrote:
>>> Some guy called me looking for a 31/32" - 28 tpi tap for a faucet. MSC
>>> and Google both come up with nothing. does it exsist?
>>>
>>> Thank You,
>>> Randy
>>
>> You are sure it is not metric?
>>
>> Dan
>
> All I know is what the guy asked me for.
It's the dreaded M24.61 0.907 TP!
--Winston
--
Support the blind and deaf. Hire a building contractor today!