Instrumentation Question

[MICHAEL KILLIAN]

I have a 1991 Sleekcraft Enforcer. I would like to add a Teleflex
Depth Gauge/Thermometer to the dash. The current instruments
are round with a plain square black bezel around them. Does
anyone know where I can get that type bezel?

I have seen a bezel in I think West Marine, however, it has
simulated screws in the corners which the ones on my boat do not
have.

If anyone knows where I can get a bezel like the one I described
for a 2 1/8 in gauge, please email me.

Thanks.
Mike Killian
Plum Wild - Captain
--
***
***
*** Every day above ground is a good day!
***

[Scott Atchley]

MICHAEL KILLIAN wrote in message <7mdc19$cp2$1...@news.asu.edu>...

>
>I have a 1991 Sleekcraft Enforcer. I would like to add a Teleflex
>Depth Gauge/Thermometer to the dash. The current instruments
>are round with a plain square black bezel around them. Does
>anyone know where I can get that type bezel?
>
>I have seen a bezel in I think West Marine, however, it has
>simulated screws in the corners which the ones on my boat do not
>have.
>
>If anyone knows where I can get a bezel like the one I described
>for a 2 1/8 in gauge, please email me.
>
>Thanks.
>Mike Killian

Teleflex has a square bezel accessory. Unfortunately, it does not fit the
depth finders.

Scott Atchley

[Don Pleu]

VDO makes the necessary black square bezels for round 2" gages.
Don

Lee Lindquist <dont...@junk.com> wrote in article
<378de600...@news.newsguy.com>...

>
> MICHAEL KILLIAN wrote in message <7mdc19$cp2$1...@news.asu.edu>...
> >>
> >>I have a 1991 Sleekcraft Enforcer. I would like to add a Teleflex
> >>Depth Gauge/Thermometer to the dash. The current instruments
> >>are round with a plain square black bezel around them. Does
> >>anyone know where I can get that type bezel?
> >>
> >>I have seen a bezel in I think West Marine, however, it has
> >>simulated screws in the corners which the ones on my boat do not
> >>have.
> >>
> >>If anyone knows where I can get a bezel like the one I described
> >>for a 2 1/8 in gauge, please email me.
>

> An easy solution is to find a plastic fabricator who can
> whip you up a rectangular piece to serve as a bezel for
> both instruments.
>
> I had this done to cover a pre-existing hole. They made
> me a piece that was about 2.5" x 6" x 1/8" with two holes,
> rounded corners, etc. I think it set me back about $5.
>
> If you're in South Florida, the place was Prospect Plastics
> in Ftc. Lauderdale.
>
>
> - Lee Lindquist
>
> {lastname}@ibm.net One whistle, captain.
>