Thanks for responding to my earlier post about the heater blower motor speed
control failure. It was the resistor and the thing is very well hidden
behind the large vent pipe that goes to the passenger side vent. It helps
to remove the passanger side dash speaker so you can actually see inside the
dash from that location. There are also two large plugs that are mounted in
the way so you have to pull them out of their mounts and plan on cutting
yourself on the sharp prongs at least once.
With the glovebox removed and the left speaker out you can ALMOST see the
resistor plug. Look for two small screws in the heater box in that
location.
After 4 attempts (and much prayer after the third attempt) the Jeep is
behaving itself once again.
Thanks again for the support,
Randy