Whew! I am debating if it would have been worth it
to let the dealer get the code for $70? It took me about 2 1/2 hours but that
was due largely because the instructions I found were not very accurate on where
to locate the CSM (Computer Security Module). If I knew exactly where to start
with, I could have completed the job in 20-30 minutes. Here is the shortcut for
anybody else to follow:
It is located on the Passenger side on the post
behind the rear door and underneath all the plastic trim. I is bolted to the
side and is under the lower trim cover.
Step 1 - Pull the rubber door gasket loose from the
bottom all around the rear of the door opening and about halfway across the
top.
Step 2 - Rotate the two metal clips that are
attached to the upper trim piece on the rear of the door opening.
Step 3 - Unsnap the
rear clips of the upper trim piece (the one where the seat belt comes out of) by
tugging on the rear edge. There are 3 clips in there in the rear.
Step 4 - Unsnap the last clip in the center up
high.
Step 5 - Remove the trim piece by pulling the
bottom of the piece outward and pulling downward. There is a metal "guide" in
the top-front area just above the seat belt opening that you will need to
watch.
Step 6 - Now remove the small metal clip that holds
the bottom plastic trim piece to the edge of the door opening. It will be down
by the bottom of the door opening.
Step 7 - Pull the top of the bottom plastic trim
piece out as much as you can to see the CSM bolted to the wall behind it. The
CSM will be the black box about 5" wide by 4" tall by 1" deep. You should wedge
something in between the trim piece and the metal of the door edge to give you
both hands free.
Step 8 - Now that you have both hands free, reach
into the CSM and pull up on the bottom of the module to rotate the front up
toward you a bit so you can see the label on the front. The 5 digit code will be
the last 5 of the numbers underneath a bar code. The 5 digits are grouped out by
themselves so you will recognize it.
Step 9 - Now before you put all this trim back,
walk around to the driver's side door and try out the code to make sure it
works.
Step 10 - Put it all back in reverse order.
DONE!
SW