I went ahead and broke them in two to remove the float but I like the idea of putting the component containers as support. However since I want the effect (illuminating the logo from the hollow) to dictate placement I don't know now where the content will go.
Thanks for all the help!
On Monday, April 2, 2012 12:34:40 PM UTC-5, Dan Hess wrote:
> If it is intended to hold something, then why not design it to hold that > content rather than being an open cavity? For the LEDs you could simply > deign recessed holes into the print for the number you want, and for the > battery you could put a more form fitting hole for it to fit into. That > may almost instantaneously provide the support needed for the majority of > it. The printer is capable of doing bridges in small sections so depending > on how that is done up it is much more likely to be able to do that than > trying to float the layers the entire length of the print.
> Thanks,
> Daniel H. > Google Voice: (901) 214-5326
> - Copying one is plagiarism, copying many is research.
