RE Opposite of M84 Stop Motor Idle Hold (order 6265)
59 views
Skip to first unread message
Matt
May 3, 2012, 7:35:18 AM5/3/12
to MakerGear - Make Today, Change Tomorrow
Hi Guys
On a makergear Prusa Mendel Ramps1.4 : Does anyone know how to do the
opposite of an M84 command. (M84 Stop Idle Hold)
I.E. I want to manually hold the motor in a stationary position.
If i Manually enter G Code to move the motor, it'll move then stop but
doesn't hold
Whereas on Gen 6 and Sangilolou boards with the same firmware setup
etc, the motor is held post movement by default
Many thanks in advance
Matt
On a makergear Prusa Mendel Ramps1.4 : Does anyone know how to do the
opposite of an M84 command. (M84 Stop Idle Hold)
I.E. I want to manually hold the motor in a stationary position.
If i Manually enter G Code to move the motor, it'll move then stop but
doesn't hold
Whereas on Gen 6 and Sangilolou boards with the same firmware setup
etc, the motor is held post movement by default
Many thanks in advance
Matt
Jordan Miller
May 3, 2012, 10:21:57 AM5/3/12
to make...@googlegroups.com
you must be talking about the z-axis only?
there are toggle settings in Marlin firmware to change this behavior
for each axis.
are you using marlin?
jordan
there are toggle settings in Marlin firmware to change this behavior
for each axis.
are you using marlin?
jordan
Reply all
Reply to author
Forward
0 new messages