> I have a simple quad copter kit I would like to sell. I rapid proto'd
> the prototype on my dimension elite and it works great.  Probably cost-
> prohibitive in volume however. I am hoping to find someone willing and
> able to print these for me.

> Here is a build thread of my quad. I am only looking at doing the
> center section and motor mounts (5 pieces total). There are no
> features less than 2mm thick. I am willing to entertain some re-design
> to make it cheaper/more-printable.

> http://www.rcgroups.com/forums/showthread.php?t=1543311

> I do have grander plans with more parts, but for now, I'd like to see
> if this is feasible. Please email me directly.

> Thanks!

> --
> You received this message because you are subscribed to the Google Groups "MakerBot Operators" group.
> To post to this group, send email to makerbot@googlegroups.com.
> To unsubscribe from this group, send email to makerbot+unsubscribe@googlegroups.com.
> For more options, visit this group at http://groups.google.com/group/makerbot?hl=en.

> I have a simple quad copter kit I would like to sell. I rapid proto'd
> the prototype on my dimension elite and it works great.  Probably cost-
> prohibitive in volume however. I am hoping to find someone willing and
> able to print these for me.

> Here is a build thread of my quad. I am only looking at doing the
> center section and motor mounts (5 pieces total). There are no
> features less than 2mm thick. I am willing to entertain some re-design
> to make it cheaper/more-printable.

> http://www.rcgroups.com/forums/showthread.php?t=1543311

> I do have grander plans with more parts, but for now, I'd like to see
> if this is feasible. Please email me directly.

> Thanks!