On 5/4/2012 10:49 PM, Paul Delgado wrote:
> After meshing some black and white x-ray scans using the v2m function,
> we obtain a surface mesh that is densely clustered at a single edge or
> corner on the lower portion of the mesh. We're not sure how to
> properly set the parameter values to obtain volume elements and
> surface faces that are roughly even throughout the mesh.
this was previously discussion in a mailing list thread,
you can see my reply here:
let me know if meshresample solves the problem.
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.