GEVCU 6 CAN data and custom evic

[Seth Miers]

I'm trying to build my own evic clone, but I can't figure out how to get dmoc information such as rpm and temperature or off the gevcu onto CAN 2. Can anyone guide me in the right direction? 

[Seth Miers]

Additionally, while not necessary, It would also be nice to let the GEVCU be aware of my Orion2 BMS.
This BMS supports custom can messages, so I should be able to make it so it looks like a ThinkCityBMS or something to trick the VCU.

But my main problem is still that I can't get any DMOC information...

[Lars Rengersen]

I Did the same using my Advanced Display Unit from Ecu Master.

The GEVCU does the 'heavy lifting' for you.

I you enable the EVIC object (device ID = 0x4400) then according to EVIC.cpp it will give you the attached data in message 0x601

Source: https://github.com/collin80/GEVCU/blob/master/EVIC.cpp

Although I found something different

- Motor RPM is unsigned

- Motor volt is unsigned

Furthermore the motor temp that is being reported is very "jumpy" in my setup.

It can go from 80 to 60 in just a second. 

Regards,

Lars

Op maandag 7 juni 2021 om 18:26:51 UTC+2 schreef miers...@gmail.com:

[Seth Miers]

Thanks for the reply! This is just what I need.

But is there a way to get this on the GEVCU CAN2?

--
You received this message because you are subscribed to a topic in the Google Groups "GEVCU-Development" group.
To unsubscribe from this topic, visit https://groups.google.com/d/topic/gevcu-development/TKZ4-tBCAdA/unsubscribe.
To unsubscribe from this group and all its topics, send an email to gevcu-developm...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/gevcu-development/ab9cf830-f2f8-4737-b759-93738735b917n%40googlegroups.com.