Incorrect level in DISFIN

[ram]

Hi all,

whenever i try to use Quick plot, The plot displays correctly but i get a warning

"Incorrect level in DISFIN <  0>"

Has anyone explain know why it  is so

ram

[Helmut Michels]

Hi,

whenever i try to use Quick plot, The plot displays correctly but i get a warning

"Incorrect level in DISFIN <  0>"

Has anyone explain know why it  is so

the quickplot routines in Dislin contain a call to disfin. Do you have an extra call to disfin
in your program? If not, which quickplot routine are you using?

Best regards,

Helmut
 

["Armin Rauthe-Schöch"]

Hi,

have a look at chapter 16.8 in the DISLIN manual:

http://www.mps.mpg.de/dislin/kap16.html#section_8


If you use "disfin()" then there should have been a call to "disini()" before the quickplot. But I think you don't need to call "disini() ... disfin()" when only using quick plots because the documentation says that this is done automatically by the quickplot routines.

Explanation:
"disini()" changes the DISLIN level from 0 to 1 and "disfin()" changes it back to 0.


While writing this email, Helmut was faster replying :-)


Cheers,
Armin

> --
> You received this message because you are subscribed to the Google Groups "dislin-users" group.
> To unsubscribe from this group and stop receiving emails from it, send an email to dislin-users...@googlegroups.com.
> For more options, visit https://groups.google.com/groups/opt_out.
>
>

--
Dr. Armin Rauthe-Schöch
Max Planck Institute for Chemistry
Department of Atmospheric Chemistry
Hahn-Meitner-Weg 1
D-55128 Mainz / GERMANY
Tel. +49-6131-305-4123
Fax. +49-6131-305-4009
Email: armin.raut...@mpic.de