Google Groups no longer supports new Usenet posts or subscriptions. Historical content remains viewable.
Dismiss

Kaypro iron bar

Skip to first unread message

Enrico Lazzerini

unread,
Jan 28, 2012, 5:30:23 PM1/28/12
to
Under the Kaypro-II there is a bar of iron that allows to position it
tilted on a table. Can someone give me the its exact sizes so that i can
create it again properly? thanks Enrico

bryan.d....@cmaaccess.com

unread,
Jan 28, 2012, 10:40:46 PM1/28/12
to
Sure. I'll shake the dust off and take some measurments and email you
the info. If I remember right it was a round rod the had several
angles bent into it.

David Griffith

unread,
Jan 29, 2012, 3:53:35 AM1/29/12
to
Please post the measurements here for posterity.

--
David Griffith
davidmy...@acm.org <--- Put my last name where it belongs

s100guy

unread,
Jan 31, 2012, 1:59:46 PM1/31/12
to
If I understand your question, the "bar" is really "L" shaped, 5/8" x
7/16" or 1/4" (hard to tell exacly without taking my Kaypros apart).
It is 18" long. It fits nicely on the back edge of the keyboard, so
that the box tilts at a nice angle.
Hope this helps.
Roger
0 new messages