Help - University project

[Isabela / Eduardo Scarabelli]

Dear all,

We have been preparing a university project using Labview software. We
need to prepare a labview program to set three pneumatic valves, that
this 3 valves will be responsable to set three pistons in a wooden
table. Could you please help me with this program?

We would like to send you an appendix with the diagram of this idea
but unfortunatly it is not possible to appendix a document here.
Because of this we will try to explain the situation below:

Imagine that these pistons are settled in a wooden table and each one
is responsable for one work.
1. One piston will be responsible for vertical movement (15
centimeters) during 60 seconds.
2. Other piston will be responsible for horizontal movement.
The wood board dimensions are: Lenght: 40 cm, Width: 20 cm, Thickness:
1,5 cm.
This piston movement will be each 7 cm, cosidering 60 seconds for each
work.
3. The third piston need is responsible to another work, he needs to
recieve a signal to make a movement of 15 centimeters.

We are looking for your help as soon as possible.
If possible, send us an email that we can send you a picture of the
system.

Thank you very much, kind regards,

Isabela / Eduardo

[Bruce Bowler]

On Thu, 04 Jun 2009 07:16:47 -0700, Isabela / Eduardo Scarabelli wrote:

> We have been preparing a university project using Labview software. We
> need to prepare a labview program to set three pneumatic valves, that
> this 3 valves will be responsable to set three pistons in a wooden
> table. Could you please help me with this program?

Wouldn't it be better to ask your professor for some help?

Bruce