Matching parathesis in fundamental mode and Error message w/ Solaris version

[Mark J. Jensen]

I've just installed Xemacs 20.3 for Solaris 2.5 and when I load a file I get

the error:

(1) (sunpro/warning) XEmacs was compiled with support for Sun Developer Products,
but neither `workshop' nor `sparcworks' were found on the PATH.

Will this cause any problems with Xemacs and is there a way to get rid of the

error.

Thanks

 
*--------------------------------------------------------------------------*
| Mark J. Jensen                                     Voice: (573) 882-9925 |
| Department of Economics,                             Fax: (573) 882-2697 |
| University of Missouri                                                   |
| 118 Professional Building                                                |
| Columbia, Missouri 65211                    jen...@haar.econ.missouri.edu|
*--------------------------------------------------------------------------*

 

[Colin Rafferty]

Mark J Jensen writes:

> I've just installed Xemacs 20.3 for Solaris 2.5 and when I load a file I get
> the error:

> (1) (sunpro/warning) XEmacs was compiled with support for Sun Developer Products,
> but neither `workshop' nor `sparcworks' were found on the PATH.

> Will this cause any problems with Xemacs...

This will not cause any problems unless you try to use sparcworks.

> ...and is there a way to get rid of the error.

There are two ways:

1. If you have one, put `workshop' or `sparcworks' on your PATH.

2. If you do not have them, install the version compiled without
sparcworks. This will get rid of the startup warning, and will give
you a smaller executable.

--
Colin