Google Groups no longer supports new Usenet posts or subscriptions. Historical content remains viewable.
Dismiss
3750 stack members
1 view
Skip to first unread message
ccie reports
Jan 5, 2010, 6:14:40 PM1/5/10
to
I have a problem with a Cisco stack with 3 members.
All 3 memebers are catalyst 3750.
Because these stack is currently not in use i will use all of them as
spare in case of one of the other switches of infrastructure will
fail.
I removed a memeber from this stack - as explained at cisco website:
powerde down the member to remove and at master - no switch 3
provision name ...exit...wr mem. This all worked. (Stack cabels were
removed too)
All 3 memebers are catalyst 3750.
Because these stack is currently not in use i will use all of them as
spare in case of one of the other switches of infrastructure will
fail.
I removed a memeber from this stack - as explained at cisco website:
powerde down the member to remove and at master - no switch 3
provision name ...exit...wr mem. This all worked. (Stack cabels were
removed too)
After powering up the removed memberexplains me that he is master -
and the interfaces are shown as 3/0/1 and so on.
This is not realy a problem but it looks not so good.
Is there any solution for this ?
I was looking at Cisco website and Switch manual for an ssolution but
i didn´t find anything.
I will be glad for an hint how to solve this
best christmas regards and wishes
CR
Cisco Certification Forum
http://CertificationChat.com
Darren Moulding
Jan 6, 2010, 12:52:01 AM1/6/10
to
"ccie reports" <ccier...@gmail.com> wrote in message
news:28a00a92-d523-4ffc...@j4g2000yqe.googlegroups.com...
I have a problem with a Cisco stack with 3 members.
All 3 memebers are catalyst 3750.
Because these stack is currently not in use i will use all of them as
spare in case of one of the other switches of infrastructure will
fail.
I removed a memeber from this stack - as explained at cisco website:
powerde down the member to remove and at master - no switch 3
provision name ...exit...wr mem. This all worked. (Stack cabels were
removed too)
After powering up the removed memberexplains me that he is master -
and the interfaces are shown as 3/0/1 and so on.
This is not realy a problem but it looks not so good.
Is there any solution for this ?
I was looking at Cisco website and Switch manual for an ssolution but
i didn�t find anything.
Pretty sure that should help.
make
Jan 6, 2010, 7:07:14 AM1/6/10
to
Use show switch, this tells that this switch is number 3. Try, command:
switch 3 renumber 1, wr mem and reload.
switch 3 renumber 1, wr mem and reload.
0 new messages