MB debug module

[ines_fr]

I'm working on a multiprocessor architecture targeting spartan 3 starter
kit. (referring to the tutorial XAPP996). I'm stuck in the phase of run
implementation set, because I could not connect the MicroBlaze to the Debug
Module "mdm"!!I used XMD debug by typing the command "connect mb mdm", but
there is an error as follows:
Info: Autodetecting cable. Please wait.
Info: Connecting to cable (Parallel Port - LPT1).
Info: Checking cable driver.
Info: Driver windrvr6.sys version = 8.1.1.0.Info: WinDriver v8.11 Jungo (c)
1997
- 2006 Build Date: October 16, 2006 X86 32bit SYS 12:35:07, version =
811.
Info: LPT base address = 0378h.
Info: ECP base address = 0778h.
Info: Cable connection established.

JTAG chain configuration
--------------------------------------------------
Device ID Code IR Length Part Name
1 01414093 6 XC3S200
2 05045093 8 XCF02S
ERROR: Could Not Detect MDM Peripheral on Hardware. Check:
1. If FPGA is Configured Correctly
2. MDM Core is Instantiated in the Design

So please, if anyone knows the solution, pleaaase my answer!!I'm stuck
with all my great appreciation!!!

INES

---------------------------------------
This message was sent using the comp.arch.fpga web interface on
http://www.FPGARelated.com

[ines_fr]