You cannot post messages because only members can post, and you are not currently a member.
Description:
Cabo Rico sailboats: owners, fans, enthusiasts
|
|
|
Halyard sizesCR 38
|
| |
Hello all,
I have looked through the achieves and thought for sure there was a posting on all rigging sizes at one time. I have a print out on the boat I am pretty sure. Due to poor winter storage by the marina we have to replace the Genoa halyard. I am having trouble finding size and length.... more »
|
|
|
That dripping forward portlight
|
| |
The portlight over the forward berth has been leaking. I bought some gasket material that was too soft and made things worse. Then I found "original" (t-shaped) gasket material for the ABI ports on line and bought some. It turns out that it looked exactly like what I had taken out of there in the... more »
|
|
|
New depth transducer? .
|
| |
Hi Everyone- Any suggestions for replacing the old depth transducer? I'm looking at the Airmar Smart Triducer DST800. Not sure the diameter of the old '85 thru-hull until the boat is pulled out in two weeks. Any thoughts would be helpful. Thanks
|
|
|
Help Finding Fasteners for Mainsheet Traveller
|
| |
I would use the 316. I got mine from a local fastener house in Myrtle Beach SC. I'll look them up if you don't have a supply house local.
Breck Caine CR 38 #19 In a message dated 4/28/2013 11:44:21 P.M. Eastern Daylight Time, ...
One of our spring upgrades is a line control setup for our Schaefer... more »
|
|
|
Help Finding Fasteners for Mainsheet Traveller
|
| |
One of our spring upgrades is a line control setup for our Schaefer traveler. The only thing that is preventing us from completing the project is finding some replacement fasteners to secure the new traveller control ends through the track and the fiberglass risers. I'm looking for 1/4"-20x6" flathead machine screws in either aluminum or 316 stainless.... more »
|
|
|
transom graphics/picture 3
|
| |
This is a "mockup" I got back from the transom graphics guy. Im nto sure
this is exactly the final thing on my transom, but pretty close. It also
has a scale bar for…scale? :)
Again, I hope it helps.
mickey
|
|
|
blank transom picture 2
|
| |
Again, this seemed to help the guy who did my grpahics:
The top of the transom athwartships just below the caprail is somewhere around
62"
|
|
|
blank transom pic 1
|
| |
I sent this to a guy who did my graphics. Note:
The top of the transom athwartships just below the caprail is somewhere around
62"
mickey
|
|
|
Transom Lettering
|
| |
We should be closing on our 1988 CR 38 XL in early June, and we are looking for some input on stern lettering size and spacing. The seller currently has the name on each quarter and we may want to move it to the stern. The boat is 4 1/2 hours away and I forgot to take measurements last time I was... more »
|
|
|
