c320-list

Yes, a real shame. David Nolte Beach House 0004 Severna Park, MD > On May 28, 2026, at 11:48 AM,

Thanks ALL! Was going to try on my own but was wondering. Def will be trying to get some help.-

Could one of you take photos of the seat and cushion and email or text them to me?Thank you in

Whew. Found the valves in the port side aft cabin. Just tiny nuts that needed turning. Water

I ordered 17 feet when I did mine. I sent you a direct email with specifics Art. Dave Hupe 1994 C320

The line that has to be taught is the Topping Lift. The Dutchman monofilament lines require

I have an extra long line for the topping lift that comes all the way back through an extra clutch on

interesting. thanks for that. I'll keep an eye out for leaks. I was able to get the frame back in

We got a queen size foam mattress from Costco and it worked very well Dick Walker > On May 17,

I suggest calling Quantum sails and then Doyle sails... They have a lot of knowledge about the 320

Yes the #7 is the largest size that is supposed to fit… I have a #6… probably a bit small in light

I went out to the Cariblue website today to try and order the all-aluminum dipstick that several on

All the sheaves are the same size. I checked them before I put everything back in. Maybe the pins

Windy City, hull #948 has come on the market. 2 jibs, 2 year old main sail with new mainsail cover ,

John- So you mean the 8 in the main cabin (2 at galley, 2 near mast, 4 along sides)? Do you mean the

Just posted. On Wed, Apr 29, 2026 at 11:28 AM Roger Sullivan <sullivan...@gmail.com> wrote

While on the hard to run my engine, I have used a rubber hose outside the boat that slips perfectly (

To unsubscribe from the C320 list go to https://www.c320.org Hover over "C320 Email Discussion

To unsubscribe from the C320 list go to https://www.c320.org Hover over "C320 Email Discussion

We recently met new (8 months) owners of a 2001 C320.We had a discussion about installing a linear

Two years back I swapped out the Raymarine wheel pilot for the EV100 RAM drive. If you look at the

I suggest just the opposite. First make sure the ends of the front line are secured and can't be

Good luck w/ that Joe! I'm gonna ask on this one too. So for the 4th time requesting - take me

Very interesting offer, it might be on my to-do list for 2027 🤔 Art Piotrowski “Maggie” 1996 #330

I found info on the Internet about cheap Chinese starters for yanmar breaking at the cone casting. I

Anyone use a drill powered transfer pump to drain the oil out of the engine, and if so, can you share

Roger- I replaced the heat exchanger tank and all associated hoses and boots several years ago on my

Hi Arturo- I'm interested in this jib. Please contact me at hottu...@outlook.com Thanks Charlie

See "contact" at the bottom of this link https://catalinayachtsstore.com/ Yahoo Mail:

There is a lot of talk about the existing shut off valve at the tank or relocating the fuel filter. I