btstack-dev

Hi Matthias; Yeah, tested with same sbc caps with "the combo" using a2dp_source_demo, it

Hi Matthias; We've already tried that and it works. Thansk for your clarification. Best Daniel 在

I finally got this to work. Thankyou so much for your time and effort. I would still be churning

HI Matthias, Thanks for the quick responses. While trying to put together a minimal example, I found

Hi Joe As there's no obvious way to automatically manage advertising, BTstack leaves this to the

Hi Joe Glad you got it working. Did you have to modify the ATT DB at run time in the end, or was it

Hi Matthias; Thanks for the information. We will do more debugging for investigation. Best regards,

I should also mention, for this use-case BTLE is off the table and I'm only focusing on using BT

Mostly from pico-examples, apart: WANT_HCI_DUMP ENABLE_GATT_OVER_EATT

> Do you have example code that gets a list of GATT Services and Characteristics? As in a Garmin

Hi Mattia The GitHub issue on the Pico SDK yo found is the “official” status page for this issue. No,

Enable le audio on bl618: O2C14/btstack_test at le-audio 在2025年2月6日星期四 UTC+8 22:38:38<harvey....@

Hi Gerriko You are right that the manual only explains how to setup services with characteristics.

Hi Matthias Thank you so much. I've tested the latest fixes and they worked successfully. BR

Hi Nikolas BTstack isn' thread-safe (by design). Please move all Bluetooth logic to the "

Hi Mitch It's recommended to start Bluetooth communication after the HCI_STATE_WORKING. BTstack

I finally got a PS5 and could do some further testing: PS5 does not support BLE keyboards. Tests were

Hi Stéphane The TLV Design only allows to store / retrieve values - and assumes that there's

Hi Stéphane We have extended the HID_SUBEVENT_INCOMING_CONNECTION event with a status field and set

I tried it without having a scan running and no reconnect was triggered. On Tuesday, February 18,

Turns out the crash is caused by enabling add_compile_definitions(PICO_USE_STACK_GUARDS=1). On Friday

Hi Edouard For HFP, you first need to establish the Service Level Connection. After that you can open

Hi Vitalli Please check out Ricardo's Bluepad32 Project https://github.com/ricardoquesada/

Hi Thomas In general, the GATT Client is supposed to trigger an MTU exchange, as you've indicated

I guess the pairing issue might be related to the initializing sequence of CYW55573. Previously my

Hi. Thank you for your time. The problem disappeared when I increased HCI_ACL_PAYLOAD_SIZE to 512 чт,

Hi Sven Sorry for the delay. The Bluetooth Core Specification basically defines the following

Hi Anton Some questions: - what port / platform are you on? - What do you mean by "spd profile

Hi Dhruv You're correct: to cover both calls and music playback, you'll need to support both

Hi Matthias Apologies for the delayed reply, I didn't notice it until yesterday. This works