Google Groups no longer supports new Usenet posts or subscriptions. Historical content remains viewable.
Dismiss
DRAWING BOARD III PROBLEM
1 view
Skip to first unread message
Becky Carr
Sep 16, 1999, 3:00:00 AM9/16/99
to
I've used my digitizer in the past with Autocad 14 with no problems. Now,
I have my cursor going all over the general area, but really OFF. I'm
using the Wintab Compatible Digitizer ADI 4.2 by Autdesk. Driver is
Version 5, Wintab Specification 1.0. Can anyone tell me what may have
happened?
I have my cursor going all over the general area, but really OFF. I'm
using the Wintab Compatible Digitizer ADI 4.2 by Autdesk. Driver is
Version 5, Wintab Specification 1.0. Can anyone tell me what may have
happened?
Thanks,
Becky Carr
Eng. Tech.
NH-ARNG, Concord, NH
Christal Elliott [Autodesk Support]
Sep 20, 1999, 3:00:00 AM9/20/99
to
Becky - Try moving the digitizer away from other electrical devices
such as the monitor. EMF interference can cause this behavior with
digitizers.
such as the monitor. EMF interference can cause this behavior with
digitizers.
On 16 Sep 1999 12:42:15 GMT, "Becky Carr"
<car...@nh-arng.ngb.army.mil> wrote:
Christal Elliott
//Autodesk Support on the Net//
0 new messages