Hi again,

I can't seem to find anything in your paper about if it's possible to use
other pins than standard serial. I would like to use other pins. I looked
in the .h file, hoping to find a initialize(rx, tw) or something, but with
no luck.

I have another device attached, that also runs per default on the standard
serial. However, with SoftwareSerial I can route that to other pins. This
gives me two really good things; 1) I don't have to disconnect RX and TX
when I'm uploading (which otherwise would result in errors), 2) I can still
use Serial.println to print out debug statements in my long program.

On p. 28 you write "Some of the I/O pins have additional functions. Pin 0
(RX) and 1 (TX) can be used for TTL12 serial communication. The Bluetooth
shield normally connects to these pins for data transmission.".

Besides power and ground, I've connected my Bluetooth Gold Mate like this;

Bluetooth.RX --> Arduino.10
Bluetooth.TX --> Arduino.9

What I am looking for is a way to use MeetAndroid on the mentioned pins.

Can you give me any pointers?

Thanks,

:-) Kasper