Where is slic3r config.ini on AHA wiki?
28 views
Skip to first unread message
Patrick Haggood
Nov 3, 2012, 9:06:20 PM11/3/12
to ahashop
Took the class this morning (great job dude!) and am now attempting to install the rest of the software to take my OpensCAD file to rewrap; i downloaded and installed the app, then I grabbed Tyler's 'awesome config file download' where I neglected to find the config.ini I need to add to slic3r as specified in the wiki here:
I also looked here:
Michael Shvartsman
Nov 3, 2012, 9:11:39 PM11/3/12
to aha...@googlegroups.com
Creamcheese just had a firmware update two nights ago, so the config is not yet uploaded and the wiki not yet updated. Stay tuned!
Everyone -- if you haven't played with the 3d printer recently, you should give it another look. With the new firmware that thing's flying.
Mike.
Tyler Worman
Nov 3, 2012, 9:26:13 PM11/3/12
to aha...@googlegroups.com
will post them sometime tomorrow evening. need to clean up the instructions a bit also. haven't had time yet. sorry!
Reply all
Reply to author
Forward
0 new messages