You cannot post messages because only members can post, and you are not currently a member.
|
Starting UAV project
|
| |
I am starting a Helicopter UAV project. I have researched some of the hardware. I am planning on converting my TRex600 to a flybarless system with Spektrum AR7200BX. I understand I need an IMU or AHRS system. Software running on my laptop with wireless or bluetooth. GPS system. Development board. Some of the hardare for IMU and AGRS systems are out of stock.... more »
|
|
|
UAV DEV BOARD on Quadcopter
|
| |
Hello all,
I just bought a UDB4 board
I was wondering is i could use it on a quadcopter
Activity here stopped last July
After some reading it seems that quad stabilization code for UDB was
tested
But i couldn't find any source code
Also it seems there was a roadmap for autopilot functions
Can one of you tell me what is the status on quadcopter and if... more »
|
|
|
Need help on Autonomous flight for Quad coptor using IMU-3
|
| |
Hello,
I am not abot to locate a code for autonomous flight for the quad
rotor. I am using UDB3 module. Could anyone help me on this?. I would
like to just write a code or modify any existying code to fly the quad
rotor only for few meters up and coming back to start point as a first
step.... more »
|
|
|
Wow... is the heli side if the UDB dormant?
|
| |
Its been like 4 months since anything has been discussed here. Or has it drifted over to the main UDB Group? I am interested in the conventional heli development. I don't have code skills, but do have platform resources and a long history with RC helis'. Alfred
|
|
|
Fwd: 4th output channel on UDB v2
|
| |
Hi Gert, I am forwarding your note to the heli group, and to John McClelland and Gerry Chapman. John has stabilized a heli using the UDB and some code that he wrote. Similarly, Gerry has stabilized a quad. I think they can help you better than I can. (John and Gerry: read the attachments to see what is... more »
|
|
|
Choosing a Heli
|
| |
Hi All
I just wanted to drop the group a line and ask what people are
currently using/ their recommendations in terms of suitable platforms.
My UDB3 has been sitting on my desk for a good month or two now just
gathering dust and finally have a little time and money on hand.
I have my eye on a flybar Trex600 ([link]... more »
|
|
|
FDTI USB Serial breakout board problem
|
| |
John, Do you use a wide, or narrow beam device in your tests? Sincerely. Marcus Fahlén I'm out of office at the moment. The information contained in this message may be CONFIDENTIAL and is intended for the addressee only. Any unauthorised use, dissemination of the information or copying of this message is prohibited. If you are not the... more »
|
|
|
Fw: [UDB-dev] Re: FDTI USB Serial breakout board problem
|
| |
----- Original Message ----- ...To: Adam Barrow Cc: John McClelland Sent: Sunday, February 06, 2011 4:49 PM ...Just wanted to close this out... I added an inverter to the sonar output and hooked up to the RX of the serial port, Vcc, GND and TX from sonar are the 3 wire connection. Hooked FTDI with 3 wire, Vcc, GND and RX from FTDI with RX going to TX of port.... more »
|
|
|
test data required
|
| |
is there any place where i can get test data for rotorcraft
propellors??
|
|
|
Discussions about development of the UAV Dev Board applied to model RC CCPM Helicopters and Quads.